Yeswelder MIG-205DS User Manual (English)

Questions and Answers:

M
Michelle JenkinsSep 9, 2025
How to troubleshoot a Yeswelder MIG-205DS Welding Accessories with a feed motor that operates but wire won't feed?
- J
  Jeffrey BrightSep 9, 2025
  If the feed motor in your Yeswelder Welding Accessories is operating, but the wire won't feed, first check the drive roller pressure and adjust it as necessary. A burr on the end of the wire can also cause this issue, so re-cut the wire to ensure it is square with no burr. Additionally, the liner might be blocked or damaged; clear it with compressed air or replace it. Finally, check and adjust the despooler tension if it is too high.
W
welliottSep 12, 2025
Why is my Yeswelder MIG-205DS Welding Accessories producing low output or non-penetrating welds?
- H
  hopkinsrickySep 12, 2025
  Low output or non-penetrating welds from your Yeswelder Welding Accessories can be attributed to several factors. Begin by adjusting the welding parameters. Ensure you're using the correct type and size wire (.023"(0.6mm)~.035"(0.9mm)). Check for poor ground or gun connections, repositioning the clamp and inspecting the cable connections. Verify the contact tip is the correct size (.023"(0.6mm) or .035"(0.9mm)) and replace if worn. Have a qualified electrician verify the voltage at your outlet and check the circuit wiring. Lastly, decrease the stick-out (the amount the wire extends past the contact tip).
A
Anthony KellySep 14, 2025
How to troubleshoot difficult arc starts with Yeswelder MIG-205DS?
- R
  Robert JonesSep 14, 2025
  If you're experiencing difficult arc starts with your Yeswelder Welding Accessories, first, try increasing the amperage setting. Ensure that the base metal is properly cleaned. If needed, replace the electrode.

Yeswelder MIG-205DS Specifications

General

Duty Cycle	60% at 205A
Protection Class	IP21S
Insulation Class	F
Input Voltage	110/220V
Welding Process	MIG, Flux Core, Stick
Weight	22.5 lbs
Input Current	30A
Wire Diameter	0.6-1.0 mm
Wire Feed Speed	1.5-15 m/min