Yeti SB120 - Switch Infinity V1 Bearing Assembly Guide; V1 Bearing Removal Steps; V1 Bearing Installation Steps

SB120 | OWNER’S MANUAL
13
SWITCH INFINITY V1 BEARING ASSEMBLY
Remove drive side bearing and axle sleeve
Remove non-drive side bearing
Press non-drive side bearing into switch innity housing (ensure extended race is facing outward
from switch innity body).
Place axle sleeve in body and press drive side bearing into housing
1 1
2
2
BEARING INSTALLBEARING REMOVAL
DRIVE SIDE BEARING DRIVE SIDE BEARING
1 2
2 1