16. 17.
01. HANGER 02. HANGER CAP
Lightly grease the outside surface of the hanger
where it interfaces with the frame. The hanger
will t into its space on the inside of the swing
arm and should press easily into the frame.
Lightly grease the threads on the hanger cap.
The hanger cap REVERSE threads into the
hanger from the outside of the swing arm. Hand
thread the cap into the hanger making sure that
the threads mesh correctly.
NOTE: The hanger cap is REVERSE
THREADED. Be careful not to strip out the
Hanger tool faces. The cap is marked with a
tighten direction arrow.
Inspect the frame around the hanger seat for
any suspicious damage any time you replace
a hanger, especially if you are replacing it due
to damage.
YETI TIPS TOOLS NEEDED
• 6mm Allen key
• Grease
DERAILLEUR HANGER INSTALL
03. TIGHTENING
Using a 6mm allen key, tighten the hanger cap
into the hanger. REMEMBER, it is REVERSE
THREADED. Follow the “Tighten” arrow on the
cap. Finish tightening with a torque wrench if
available.
*Torque to 80 in/lbs (9Nm)
To Next Page
Loading...
