YILMAZ ACK 700 - User Manual

Questions and Answers

S
Stacy PierceAug 6, 2025
How to improve surface quality when cutting with YILMAZ Saw?
- M
  Michael ManningAug 6, 2025
  If your YILMAZ Saw is producing rough surfaces, large chips, or uneven cuts, and you notice saw blade traces, it may be due to several reasons. First, ensure the saw blade is adequately cooled by lubricating the cutting surfaces or using cooling liquid. Another potential cause is a damaged or blunt saw blade; inspect the teeth and replace it if necessary. Lastly, the cutting speed might be too high for the material; try decreasing the cutting speed.
K
kbrownAug 14, 2025
What to do if pneumatic clamp pistons don't work on YILMAZ Saw?
- C
  Charles EstradaAug 14, 2025
  If the pneumatic clamp pistons on your YILMAZ Saw aren't working, the issue might stem from the air supply. Check the air compressor connections to ensure they are properly connected. Also, verify that the air pressure is correctly adjusted to between 6-8 Bar on the conditioner.
E
Elizabeth MullinsAug 21, 2025
Why motor does not work on YILMAZ ACK 700 Saw?
- D
  davidadkinsAug 21, 2025
  If the motor of your YILMAZ Saw isn't starting when you press the start button, the issue might be a lack of power supply to the machine. Check the electric cable connections and the electric power sockets to ensure they are properly connected and functioning.
J
John EdwardsAug 27, 2025
What to do if YILMAZ Saw blade rotates in reverse direction?
- R
  Robert BlankenshipAug 27, 2025
  If the saw blade on your YILMAZ Saw is rotating in reverse, it indicates a problem with the electrical connections. This could be due to incorrect wiring in the power cable or at the panel. It is recommended to have a qualified electrician inspect and correct the electrical connections.