IM 5E1E70-01E
21
8. PROGRAM OPERATING FUNCTION
■ Overview of Program Setting
To operate the controller using a program, first create the program. The UP150 have one program pattern.
Program operation is based on a program pattern consisting of up to 16 segments as shown in the figure below. To
create a program pattern, set the target setpoint to be rached and segment time for each segment. Tow PV events
and/or two time event can be set for a program.
0°C
50°C
EOFF
EON
100°C
30
Min.
30
Min.
20
Min.
30
Min.
30
Min.
30
Min.
35
Min.
30
Min.
Segment No.
Destination target value (SP)
Segment time (TM)
(Hour; Min.)
EON1
EOF1
AL1
A1
HY1
EON2
EOF2
AL2
A2
HY2
0:30
1:20
1(PV high limit)
110°C
10°C
Time event 1
(EV1=1)
PV event 1
(EV1=0)
Time event 2
(EV2=1)
PV event 2
(EV2=0)
12345678910111213141516
50°C50°C 100°C 100°C50°C50°C0°C
0:30 0:30 0:20 0:30 0:30 0:35 0:30
100%
0%
PV high limit (110°C)
0:30 (EVENT ON)
1:20 (EVENT OFF)
Program Pattern Settings
To Next Page
Loading...
