2.Triggering through synchronization
interface
Insert the triggering cable(excluded) into
the 3.5mm synchronization trigger port,
and use the camera or universal wireless
flash trigger to synchronize the flash.
Set the flash to radio mode and set the
flash mode to [M] or [MULTI].If the flash is
set to TTL or OFF, it will not be able to flash.
3.Triggering through optical transmission
(see page 9)
A: Using synchronizing flash (S1, S2)
Supports flash mode: M
B: Triggering through flash with master unit
(optical transmission)
Supports optical transmission channel 1-4,
grouping A/B/C
Supports flash mode: ETTL, M
Controlled by the compatible master flash
(camera)
1.Triggering through radio module (see page 7-8)
YN200 can only be used as a slave flash, and Yongnuo YN560-TX PRO
series flash transmitter is recommended as the main control unit,
whi c h sup por t s T TL, m a nu a l, mu lti f las h , an d h igh -sp eed
synchronization.
Press [ ] button to set it to [ ] radio mode, and set it to the same
channel and ID as the master unit.
Triggering Mode Selection
Positioning and Operation Range
(Example of wireless flash shooting)
Before shooting, perform a test flash
and test shooting.
The transmission distance may be
shorter depending on the conditions
such as the positioning of slave units, the
surrounding environment and weather
conditions.
-6-