York B1HA024A06 - User Manual

GENERAL
YORK Model B1HA units are factory assembled heat pumps
designed for outdoor installation on a rooftop or a slab. Field-
installed electric heater accessories are available to provide
supplemental electric heat combined with electric cooling and
heating.
The units are completely assembled on rigid, removable
base rails. All piping, refrigerant charge, and electrical wiring
is factory installed and tested. The units require only electric
power and duct connections at the point of installation.
The electric heaters have nickel-chrome resistance wire ele
-
ments and utilize single point power connection.
INSPECTION
As soon as a unit is received, it should be inspected for pos
-
sible damage during transit. If damage is evident, the extent
of the damage should be noted on the carrier's freight bill. A
separate request for inspection by the carrier's agent should
be made in writing. Refer to Form 50.15-NM for additional in
-
formation.
REFERENCE
Additional information on the design, installation, operation
and service of this equipment is available in the following refer-
ence forms:
• 55.70-N1 -General Installation
• 55.70-N2 -Pre-start & Post-start Check List
• 511.26-N1.1V -Electric Heater Accessory
RENEWAL PARTS
•
Refer to Replacement PartsManual for complete listing of
replacement parts on this equipment.
All forms referenced in this instruction may be ordered from:
Standard Register
2101 West Techumseh Road
Norman, OK 73069
Toll Free: Tel. 877-318-9675/Fax. 877-379-7920
CHAMPION® SERIES
SINGLE PACKAGE HEAT PUMPS
Supersedes: 035-16004-000 (0801)
035-16004-001-A-0202
INSTALLATION INSTRUCTION

MODELS B1HA018 THRU 060
1.5 THRU 5 TON
(10 SEER)
Installer should pay particular attention to the words: NOTE, CAUTION and WARNING. Notes are intended to clarify or
make the installation easier. Cautions
are given to prevent equipment damage. Warnings are given to alert installer that per
-
sonal injury and/or equipment damage may result if installation procedure is not handled properly.
CAUTION
THE ENCLOSED INSTALLATION INSTRUCTIONS AND ANY APPLICABLE
LOCAL, STATE, AND NATIONAL CODES INCLUDING, BUT NOT LIMITED
TO, BUILDING, ELECTRICAL, AND MECHANICAL CODES.
THIS PRODUCT MUST BE INSTALLED IN STRICT COMPLIANCE WITH
WARNING
OPERATION OF THE PRODUCT COULD CAUSE PERSONAL INJURY
OR PROPERTY DAMAGE.
INCORRECT INSTALLATION MAY CREATE A CONDITION WHERE THE

Summary

INSTALLATION SAFETY PRECAUTIONS

CAUTION: INSTALLATION COMPLIANCE

Install unit strictly in compliance with instructions and applicable codes.

WARNING: POTENTIAL HAZARDS

Incorrect installation may cause personal injury or property damage.

INSTALLATION GUIDELINES

PROPER LOCATION SELECTION

RIGGING AND HANDLING PROCEDURES

CONTROL AND POWER WIRING

THERMOSTAT AND CONTROL WIRING

Wiring diagram and notes for thermostat and unit control connections.

FIELD POWER WIRING

Typical field wiring diagram for connecting the unit to the power supply.

SUPPLY AIR CFM MEASUREMENT

AIRFLOW MEASUREMENT WARNING

Failure to adjust system air quantity can result in extensive damage.

SEQUENCE OF OPERATION

ANTI-SHORT CYCLE TIMER FUNCTION

COOLING MODE OPERATION DETAILS

Step-by-step operation of the unit in cooling mode with thermostat control.

HEATING MODE OPERATION DETAILS

DEFROST MODE EXPLANATION

Initiation, termination, and operation of the defrost cycle with electric heat.

SAFETY SWITCH AND LOCKOUT

Function of heat pump safety switches and lockout conditions.

ROUTINE MAINTENANCE PROCEDURES

GENERAL MAINTENANCE TASKS

OUTDOOR COIL CLEANING INSTRUCTIONS

WIRING DIAGRAM REFERENCE

WIRING DIAGRAM SYMBOL LEGEND

WIRING DIAGRAM INSTALLATION NOTES

SERVICING SAFETY CAUTION

Safety warning to open all disconnects before servicing the unit.

York B1HA024A06 Specifications

General

Model Number	B1HA024A06
Category	Heat Pump
Brand	York
Cooling Capacity (BTU/h)	24, 000
SEER Rating	Up to 16
Refrigerant Type	R-410A
Voltage (V)	208/230
Phase	1
Compressor Type	Scroll
Sound Level (Outdoor Unit, dB)	74
Tonnage	2 tons
Heating Capacity (BTU/h)	24, 000