York B1HA060A25 User Manual

GENERAL
YORK Model B1HA units are factory assembled heat pumps
designed for outdoor installation on a rooftop or a slab. Field-
installed electric heater accessories are available to provide
supplemental electric heat combined with electric cooling and
heating.
The units are completely assembled on rigid, removable
base rails. All piping, refrigerant charge, and electrical wiring
is factory installed and tested. The units require only electric
power and duct connections at the point of installation.
The electric heaters have nickel-chrome resistance wire ele
-
ments and utilize single point power connection.
INSPECTION
As soon as a unit is received, it should be inspected for pos
-
sible damage during transit. If damage is evident, the extent
of the damage should be noted on the carrier's freight bill. A
separate request for inspection by the carrier's agent should
be made in writing. Refer to Form 50.15-NM for additional in
-
formation.
REFERENCE
Additional information on the design, installation, operation
and service of this equipment is available in the following refer-
ence forms:
• 55.70-N1 -General Installation
• 55.70-N2 -Pre-start & Post-start Check List
• 511.26-N1.1V -Electric Heater Accessory
RENEWAL PARTS
•
Refer to Replacement PartsManual for complete listing of
replacement parts on this equipment.
All forms referenced in this instruction may be ordered from:
Standard Register
2101 West Techumseh Road
Norman, OK 73069
Toll Free: Tel. 877-318-9675/Fax. 877-379-7920
CHAMPION® SERIES
SINGLE PACKAGE HEAT PUMPS
Supersedes: 035-16004-000 (0801)
035-16004-001-A-0202
INSTALLATION INSTRUCTION

MODELS B1HA018 THRU 060
1.5 THRU 5 TON
(10 SEER)
Installer should pay particular attention to the words: NOTE, CAUTION and WARNING. Notes are intended to clarify or
make the installation easier. Cautions
are given to prevent equipment damage. Warnings are given to alert installer that per
-
sonal injury and/or equipment damage may result if installation procedure is not handled properly.
CAUTION
THE ENCLOSED INSTALLATION INSTRUCTIONS AND ANY APPLICABLE
LOCAL, STATE, AND NATIONAL CODES INCLUDING, BUT NOT LIMITED
TO, BUILDING, ELECTRICAL, AND MECHANICAL CODES.
THIS PRODUCT MUST BE INSTALLED IN STRICT COMPLIANCE WITH
WARNING
OPERATION OF THE PRODUCT COULD CAUSE PERSONAL INJURY
OR PROPERTY DAMAGE.
INCORRECT INSTALLATION MAY CREATE A CONDITION WHERE THE

York B1HA060A25 Specifications

General

Model	B1HA060A25
Type	Heat Pump
Cooling Capacity	60, 000 BTU
Heating Capacity	60, 000 BTU
Refrigerant	R-410A
Voltage	208/230V
Phase	1
Compressor Type	Scroll
Stages	Single Stage
Sound Level (Outdoor Unit)	76 dB

Summary

Product Overview and Inspection

General Product Description

Overview of YORK CHAMPION SERIES Single Package Heat Pumps.

Unit Inspection Upon Receipt

Procedure for inspecting the unit for transit damage and reporting.

Reference and Parts Information

Lists supplementary reference forms and instructions for ordering renewal parts.

Installation Requirements and Procedures

Installation Limitations and Codes

Compliance with national/local codes, voltage, and temperature limits.

Unit Location and Placement

Guidelines for selecting an outdoor installation location, including pad or roof mounting.

Rigging and Handling Instructions

Safe methods for lifting, moving, and positioning the unit.

Clearances and Ductwork

Required clearances and guidelines for connecting supply/return air ductwork.

Filter and Condensate Drain Setup

Importance of filters and condensate drain installation requirements.

Electrical Wiring and Service Access

Field wiring compliance, grounding, and access to service panels.

Thermostat and Compressor Installation

Thermostat placement/wiring and compressor handling during installation.

Unit Operation and Safety Sequence

Cooling Mode Operation

Sequence of operations for the unit in cooling mode.

Heating Mode Operation

Sequence of operations for the unit in heating mode.

Defrost and Safety Switch Logic

Explanation of defrost cycles and safety switch functions.

Owner Approval and System Familiarization

Securing owner's approval and instructing them on unit operation.

Routine Maintenance and Care

Filter and Coil Maintenance

Procedures for regular filter replacement and outdoor coil cleaning.

Motor Lubrication Information

Note on permanent lubrication for fan motors.