York B1HA018A06 - User Manual

GENERAL
YORK Model B1HA units are factory assembled heat pumps
designed for outdoor installation on a rooftop or a slab. Field-
installed electric heater accessories are available to provide
supplemental electric heat combined with electric cooling and
heating.
The units are completely assembled on rigid, removable
base rails. All piping, refrigerant charge, and electrical wiring
is factory installed and tested. The units require only electric
power and duct connections at the point of installation.
The electric heaters have nickel-chrome resistance wire ele
-
ments and utilize single point power connection.
INSPECTION
As soon as a unit is received, it should be inspected for pos
-
sible damage during transit. If damage is evident, the extent
of the damage should be noted on the carrier's freight bill. A
separate request for inspection by the carrier's agent should
be made in writing. Refer to Form 50.15-NM for additional in
-
formation.
REFERENCE
Additional information on the design, installation, operation
and service of this equipment is available in the following refer-
ence forms:
• 55.70-N1 -General Installation
• 55.70-N2 -Pre-start & Post-start Check List
• 511.26-N1.1V -Electric Heater Accessory
RENEWAL PARTS
•
Refer to Replacement PartsManual for complete listing of
replacement parts on this equipment.
All forms referenced in this instruction may be ordered from:
Standard Register
2101 West Techumseh Road
Norman, OK 73069
Toll Free: Tel. 877-318-9675/Fax. 877-379-7920
CHAMPION® SERIES
SINGLE PACKAGE HEAT PUMPS
Supersedes: 035-16004-000 (0801)
035-16004-001-A-0202
INSTALLATION INSTRUCTION

MODELS B1HA018 THRU 060
1.5 THRU 5 TON
(10 SEER)
Installer should pay particular attention to the words: NOTE, CAUTION and WARNING. Notes are intended to clarify or
make the installation easier. Cautions
are given to prevent equipment damage. Warnings are given to alert installer that per
-
sonal injury and/or equipment damage may result if installation procedure is not handled properly.
CAUTION
THE ENCLOSED INSTALLATION INSTRUCTIONS AND ANY APPLICABLE
LOCAL, STATE, AND NATIONAL CODES INCLUDING, BUT NOT LIMITED
TO, BUILDING, ELECTRICAL, AND MECHANICAL CODES.
THIS PRODUCT MUST BE INSTALLED IN STRICT COMPLIANCE WITH
WARNING
OPERATION OF THE PRODUCT COULD CAUSE PERSONAL INJURY
OR PROPERTY DAMAGE.
INCORRECT INSTALLATION MAY CREATE A CONDITION WHERE THE

Summary

General Information

Reference and Renewal Parts

Product Limitations and Installation

Rigging, Handling, and Location

Installation Clearances

Duct Work, Filters, and Drains

Wiring and Controls

Service Access and Components

Thermostat and Compressor Information

Checking Supply Air CFM

Unit Operation Sequence

Cooling Operation

Describes the unit's operation when the thermostat is set to cooling mode.

Heating Operation

Details the unit's operation during heating mode, including supplemental heat.

Defrost Operation

Explains the defrost cycle initiation, termination, and energizing of electric heat.

Heat Pump Safety Switch Operation

Covers safety switch functions, lockout periods, and reset procedures for the refrigeration system.

Electric Heat Limit Switch Operation

Describes the operation of the electric heat limit switch, soft/hard lockout conditions, and clearing states.

Owner Approval and Maintenance

York B1HA018A06 Specifications

General

Model	B1HA018A06
Type	Heat Pump
Cooling Capacity (BTU/h)	18000
Heating Capacity (BTU/h)	18000
Voltage	208/230
Phase	1
Refrigerant	R-410A
Tonnage	1.5
Power Supply	208/230V, 1Ph, 60Hz