FIG. 10 - DIMENSIONS & CLEARANCES (Cont’d.)- DCE & DCG
DETAIL “X”
ACCESSORY SIDE SUPPLY AND RETURN AIR OPENINGS
DUCT COVERS - Units are shipped with the bottom
duct openings covered. An accessory flange kit is avail-
able for connecting side ducts.
For
bottom duct applications:
1. Remove the side panels from the supply and return
air compartments to gain access to the bottom
supply and return air duct covers.
2. Remove and discard the bottom duct covers. (Duct
openings are closed with sheet metal covers except
when the unit includes a power exhaust option. The
covering consists of a heavy black paper composition.)
3. Replace the side supply and return air compartment
panels.
For
side duct applications;
1. Replace the side panels on the supply and return air
compartments with the accessory flange kit panels.
2. Connect ductwork to the duct flanges on the rear of
the unit.
39-5/8
FIXED OUTDOOR AIR OR
BAROMETRIC RELIEF RAIN HOOD
REAR VIEW L.H. END VIE
23-3/8" 2"
3-3/4"
28"
10-5/8"
27"
3/4" CONDENSATE
DRAIN
(MUST BE TRAPPED)
7"
(B) POWER
ENTRY
29-5/8"
3-1/2"
4-1/2"
71"
ECONOMIZER
RAIN HOOD
DETAIL “Y”
UNIT WITH RAIN HOODS
66-1/2"
36"
530.18-N11Y
12 Unitary Products Group
To Next Page
Loading...
