5120410-XIM-B-0216
4 Johnson Controls Unitary Products
Reference
Additional information is available in the following reference
forms:
• Technical Guide - DC090-150, 637367
• General Installation - DC090-150, 5120410
Renewal Parts
Contact your local York
®
parts distribution center for authorized
replacement parts.
Approvals
Design certified by CSA as follows:
1. For use as a cooling only unit, cooling unit with
supplemental electric heat or a forced air furnace.
2. For outdoor installation only.
3. For installation on combustible material and may be
installed directly on combustible flooring or, in the U.S., on
wood flooring or Class A, Class B or Class C roof covering
materials.
4. For use with natural gas (convertible to LP with kit).
This product must be installed in strict compliance with
the enclosed installation instructions and any applicable
local, state and national codes including, but not limited
to, building, electrical, and mechanical codes.
The furnace and its individual shut-off valve must be
disconnected from the gas supply piping system during
any pressure testing at pressures in excess of 1/2 PSIG.
Pressures greater than 1/2 PSIG will cause gas valve
damage resulting in a hazardous condition. If it is
subjected to a pressure greater than 1/2 PSIG, the gas
valve must be replaced.
The furnace must be isolated from the gas supply piping
system by closing its individual manual shut-off valve
during any pressure testing of the gas supply piping
system at test pressures equal to or less than 1/2 PSIG
This product must be installed in strict compliance with
the enclosed installation instructions and any applicable
local, state, and national codes including, but not limited
to, building, electrical, and mechanical codes.
Improper installation may create a condition where the
operation of the product could cause personal injury or
property damage.
UNIT CHARGED WITH NITROGEN
TO PROPERLY START THIS EQUIPMENT, VENT THE
NITROGEN AND VACUUM THE SYSTEM(S) BELOW
500 MICRONS.
WEIGH IN THE CORRECT AMOUNT OF
REFRIGERANT BEFORE STARTING THE UNIT.
To Next Page
Loading...
Need help?
General
