York DCMF09NWM42Q1 - Outdoor Unit Removal Procedure (Continued); Compressor and Isolation Sheet Removal; Condenser and Chassis Removal

Johnson Controls Unitary Products 33
923178-UTG-B-0114
13. Remove compressor
14. Remove isolation sheet
15. Remove support plate of condenser
16. Remove chassis and condenser
STEPS PROCEDURES
Compressor
Twist off the 3 foot nuts on
compressor and then remove
the compressor.
Isolation
Sheet
Twist off the screws connecting
isolation sheet and end plate of
condenser and chassis, and then
remove the isolation sheet.
Support Plate
of Condenser
Twist off the screws connecting
the support plate of condenser
and condenser with screwdriver,
and then remove the support
plate of condenser.
Condenser
Chassis
Pull it upwards to separate
the chassis and condenser.