167791-BIM-B-0606
6 Unitary Products Group
REFERENCE
Additional information is available in the following reference
forms:
• Technical Guide - DU-06 thru -12, 246650
• Technical Guide - DL-06 thru -12, 246713
• General Installation - DU/DL-06 thru -12, 167791
• Pre-start & Post-start Check List
• Economizer Accessory -
Downflow Factory Installed
Downflow Field Installed
Horizontal Field Installed
• Motorized Outdoor Air Damper
• Manual Outdoor Air Damper (0-100%)
• Manual Outdoor Air Damper (0-35%)
• Gas Heat Propane Conversion Kit
• Gas Heat High Altitude Kit (Natural Gas)
• Gas Heat High Altitude Kit (Propane)
• –60°F Gas Heat Kit
• Electric Heater Accessory 50” cabinet
• Electric Heater Accessory 42” cabinet
RENEWAL PARTS
Contact your local UPG parts distribution center for autho-
rized replacement parts.
APPROVALS
Design certified by CSA as follows:
1. For use as a cooling only unit, cooling unit with supple-
mental electric heat or a forced air furnace.
2. For outdoor installation only.
3. For installation on combustible material and may be
installed directly on combustible flooring or, in the U.S.,
on wood flooring or Class A, Class B or Class C roof cov-
ering materials.
4. For use with natural gas (convertible to LP with kit).
The installer should pay particular attention to the words:
NOTE, CAUTION, and WARNING. NOTES are intended to
clarify or make the installation easier. CAUTIONS are given
to prevent equipment damage. WARNINGS are given to alert
installer that personal injury and/or equipment damage may
result if installation procedure is not handled properly.
This product must be installed in strict compliance
with the enclosed installation instructions and any
applicable local, state, and national codes including,
but not limited to, building, electrical, and mechanical
codes.
Improper installation may create a condition where the
operation of the product could cause personal injury
or property damage.
To Next Page
Loading...
Need help?
General
