What to do if my York P*UR is showing 4 FLASH?
If your York Furnace is showing 4 FLASH, it could be due to a dirty filter, improperly sized duct system, incorrect blower speed setting, incorrect firing rate, or a faulty blower motor. To resolve this, clean or replace the filter, check the duct size, adjust the blower speed, check the firing rate, or replace the blower motor as needed.
What does 3 FLASH mean on my York P*UR Furnace and how to fix it?
If your York Furnace shows 3 FLASH, the possible causes are a faulty inducer, a blocked vent pipe, a broken pressure switch hose, or a faulty pressure switch. You should inspect and rectify each of these potential issues.
Why is my York P*UR Furnace showing CONTINUOUS FLASH?
A York Furnace showing a CONTINUOUS FLASH indicates a gas valve that leaks or is slow to close. Check the gas valve and control for proper operation.
What does 7 FLASH mean on my York Furnace?
If your York Furnace displays 7 FLASH, this may be due to low gas pressure, a faulty gas valve, a faulty hot surface ignitor, or a burner problem. Inspect and repair any of the mentioned components.
What does 5 FLASH mean on my York Furnace?
If your York Furnace is showing 5 FLASH, it indicates a primary heat exchanger failure or burner problem. Check for proper combustion air and inducer operation, and manually reset the rollout switch after correcting any failures.
Why is my York Furnace showing 8 FLASH?
If your York Furnace is showing 8 FLASH, it could be due to low gas pressure or a faulty gas valve. Inspect the gas supply and valve.
What does 2 FLASH mean on my York P*UR?
If your York Furnace is showing 2 FLASH, it indicates a faulty pressure switch or mis-wiring. Replace the faulty pressure switch.
What does STEADY ON mean on a York Furnace?
If your York Furnace shows a STEADY ON, check the gas valve and control for proper operation.
What does 11 FLASH mean on my York P*UR?
If your York Furnace displays 11 FLASH, it means an improper ground is present. Verify that the unit is properly grounded, and if the fault persists, replace the control.
Provides an overview of the furnace's features, design, and intended applications.
Highlights critical safety and operational advisories for installers.
Explains the interlock switch that powers off the unit when the blower door is removed.
Details manual reset controls on the burner box that de-energize the unit if overheated.
Explains switches monitoring combustion air/vent piping flow.
Describes the high-temperature limit control on the vestibule panel.
Procedure to verify natural gas input rate using a test dial meter.
Describes the step-by-step process of the furnace's heating cycle.
Details the sequence from thermostat call to burner ignition and blower start.
Explains the furnace's self-diagnostic capability and fault codes.
To Next Page
General
