YORK INTERNATIONAL
81
FORM 150.62-NM7 (103)
Displays the number of fan stages in the system ac tive
at the time of the fault.
Displays the system amperage (calculated ap prox i-
mate ly) and, DC feedback voltage from the 2ACE
Mod ule, at the time of the fault.
For this message to appear, CURRENT FEEDBACK
ONE PER SYSTEM must be programmed under the op-
tions key. If the micro is programmed as one CUR RENT
FEEDBACK ONE PER UNIT under the pro gram key, the
display will be the fi rst display prior to the SYS 1 info. If
the micro is programmed for CUR RENT FEED BACK
NONE, no current display will ap pear.
Displays for System 1 starting with SYS X NUMBER OF
COMPS RUNNING X through SYS X AMPS = XXX.X
VOLTS = X.X will be displayed fi rst, followed by dis plays
for System 2.
Further explanation of the above displays is covered un-
der the STATUS, OPER DATA, COOLING SETPOINTS,
PROGRAM, and OPTIONS keys.
S Y S X F A N S T A G E X X X
S Y S X A M P S = 4 0 . 3
V O L T S = 2 . 2
2
To Next Page
Loading...
