Transport of the wheelchair
22
Figure 6.1
6.2.1 Removing the seat
1. Pull up the seat in front.
When replacing the seat, the clips (B in figure 6.1) must click around the round bar in
the frame. Check if the seat has been clicked into place securely.
6.2.2 Removing the legrests
1. Push the catch backward to unlock the legrest.
2. Swing the legrest outward.
3. Raise the legrest and remove it from the legrest holder.
When the legrest is returned to its original position, you should hear a click. Only then
can you be certain that the legrest is securely locked in place.
6.2.3 Removing the armrests
1. Unscrew the cap and remove the armrest. If the wheelchair has been equipped
with lights, disconnect the lighting plug.
The controller will remain connected to the wheelchair by its wiring.
6.2.4 Folding down the backrest
1. Flip the lock clip (C in figure 6.1) off the adjusting bar (D in figure 6.1).
2. Pull the lock clip out of the hinged joint.
3. Fold down the backrest.
To Next Page
Loading...
