Z1 CPAP System - Care and Maintenance; Inspections Before Use; Daily and Weekly Cleaning

To Next Page

To Previous Page

Care

The Z1 System needs periodic care. It is the user’s responsibility to be aware of the following items

for care:

• Inspections

• Cleaning

• Filter Replacement

• CPAP Tube Replacement

• Reminders and Fault Conditions

Inspections

Before each use carefully inspect the Z1, CPAP Tube, Filter, and mask for signs of wear, damage

or discoloration. Contact Human Design Medical for replacement parts at 1-855-436-8724

[1-855-HDMUSA4] or online at www.hdmusa.com.

Cleaning

Regular cleaning should be performed in accordance with the instructions below.

WARNING: This device can expose you to electrocution. Do not

immerse the Z1, Power Adapter, Power Cord or Battery in water. Always

unplug these devices before cleaning (only as instructed in this User Guide)

and make sure they are dry before plugging back in.

CAUTION: Do not use bleach, chlorine, alcohol, or aromatic-based

solutions, moisturizing or antibacterial soaps or scented oils to clean the

Z1. Never attempt to clean the Power Adapter, PowerShell, Battery or

accessories with any of these solutions. These solutions may create a shock

hazard, cause damage and reduce the life of these products.

Daily

1. Remove the CPAP Tube and the mask from the Z1.

2. Refer to the instructions for cleaning, maintenance and replacement provided with

your CPAP Tube and mask.

3. Before next use, reconnect the CPAP Tube and the Tube Adapter to the Z1 and mask.

Weekly

1. Remove the CPAP Tube, Tube Adapter and mask from the Z1. Wash the Tube Adapter

in warm water using a mild detergent. Rinse thoroughly and allow to dry.

Refer to the manufacturer’s instructions for cleaning the CPAP Tube and mask.

2. Before next use, reconnect the CPAP Tube to the Tube Adapter and then to the Z1 and

mask.