TO CLOSE, LINE UP THE CUTOUT IN THE
ZAGGkeys PRO/PROplus WITH THE 30-PIN
CHARGER PORT ON iPAD®, AND PLACE iPAD®
FACE DOWN ONTO THE PRO/PROplus. THE
MAGNETS WILL ATTRACT AND SECURE iPAD®
TO THE ZAGGkeys PRO/PROplus. iPAD® WILL
AUTOMATICALLY SWITCH TO SLEEP MODE
WHEN SECURED IN THE ZAGGkeys PRO/PROplus
AND START UP WHEN THE DEVICES ARE
SEPARATED. THIS FUNCTION CAN BE
TOGGLED ON OR OFF IN THE SETTINGS
MENU OF YOUR iPAD®.
NOTE: THE ZAGGkeys PRO/PROplus AND
iPAD® MUST BE ALIGNED PROPERLY FOR
THE MAGNET CLOSURE TO FUNCTION. IF
THE ALIGNMENT IS NOT CORRECT, THE
MAGNETS WILL NOT ATTRACT.
POSITIONING
SIMPLY PLACE iPAD® EITHER
VERTICALLY OR
HORIZONTALLY INTO THE
SLOT AND LEAN THE DEVICE
BACK. WHEN IN LANDSCAPE
ORIENTATION, MAGNETS IN
THE PRO/PROPLUS CENTRAL
GROOVE WILL HELP SECURE iPAD®.
CENTRAL GROOVE
5. ON THE iPAD®, SELECT:
SETTINGS > GENERAL > BLUETOOTH > ON.
6. IF YOU SEE ZAGGkeys PRO/PROplus LISTED AS AN
“AVAILABLE DEVICE” ON YOUR iPAD®, CLICK
ON THE ARROW TO THE RIGHT AND CHOOSE
TO HAVE YOUR iPAD® “FORGET THE DEVICE.”
7. CLICK PAIR BUTTON ON ZAGGkeys PRO/PROplus
AND WATCH FOR THE CAPS LOCK LIGHT TO
FLASH.
8. YOU SHOULD SEE ZAGGkeys PRO/PROplus
LISTED AS AN “AVAILABLE DEVICE.”
9. SELECT ZAGGkeys PRO/PROplus BY TOUCHING
IT ON YOUR iPAD®.
10. YOUR ZAGGkeys PRO/PROplus SHOULD
NOW BE PAIRED.
11. IF YOUR iPAD® GIVES YOU AN ERROR MESSAGE,
REPEAT PROCESS AGAIN.
12. IF YOU STILL CAN’T GET YOUR ZAGGkeys
PRO/PROplus TO PAIR, IT IS POSSIBLE YOUR iPAD®
NEEDS TO HAVE ITS SOFTWARE UPDATED.
13. IF BACKLIGHTING IS NOT OPERATING: BATTERY
MAY NEED TO BE CHARGED AS BACKLIT KEYS
WILL NOT OPERATE WHEN BATTERY LIFE
FALLS BELOW 20%.
FOLD
PAGE 1
PAGE 8
To Next Page
Loading...
