POWERING ON AND PAIRING YOUR
ZAGGkeys PRO/PROplus
THE ZAGGkeys PRO/PROplus’s BLUETOOTH
KEYBOARD SHOULD ONLY NEED TO PAIR TO
YOUR iPAD® ONCE AS FOLLOWS:
1. ON THE ZAGGkeys PRO/PROplus, SLIDE THE
POWER BUTTON ON. THE BLUE CAPS LOCK
LIGHT WILL ILLUMINATE FOR FOUR SECONDS
AND THEN TURN OFF TO SAVE POWER. YOUR
ZAGGkeys PRO/PROplus IS STILL ON.
2. PRESS THE PAIR BUTTON AND THE CAPS
LOCK LIGHT WILL FLASH INDICATING THAT
YOUR PRO/PROplus IS READY TO PAIR.
3. ON THE iPAD®, SELECT: SETTINGS >
GENERAL > BLUETOOTH > ON.
4. THE CAPS LOCK LIGHT WILL FLASH ON THE
PRO/PROplus AND THE iPAD® WILL DISPLAY
“ZAGGkeys PRO/PROplus” AS AN AVAILABLE
DEVICE.
5. SELECT “ZAGGkeys PRO/PROplus” ON THE
iPAD®; TO PAIR.
6. YOUR iPAD® AND PRO/PROplus WILL
AUTOMATICALLY PAIR.
WHAT TO DO IF THE iPAD® DOES NOT RESPOND TO
THE ZAGGkeys PRO/PROplus.
A FEW THINGS CAN CAUSE THIS PROBLEM:
-DEAD BATTERY
-NEED TO PAIR THE ZAGGkeys PRO/PROplus
TO YOUR iPAD® AGAIN
-OLD iPAD® SOFTWARE
-PROBLEM WITH ZAGGkeys PRO/PROplus
PLEASE FOLLOW THE LIST BELOW TO FIND THE
PROBLEM AND APPROPRIATE SOLUTION.
1. RESTART YOUR iPAD® BY HOLDING DOWN THE
HOME AND POWER BUTTON SIMULTANEOUSLY
UNTIL IT RESETS. LET GO OF THE BUTTONS
WHEN YOU SEE THE APPLE® LOGO.
2. TURN OFF ZAGGkeys PRO/PROplus.
3. TURN THE ZAGGkeys PRO/PROplus ON. YOU
SHOULD SEE THE CAPS LOCK LIGHT TURN ON
FOR ABOUT 4 SECONDS AND THEN TURN OFF.
IF NOT, CHARGE YOUR ZAGGkeys PRO/PROplus.
4. AFTER CHARGING, SLIDE THE POWER SWITCH
ON. IF THE CAPS LOCK LIGHT DOES NOT
ILLUMINATE FOR A FEW SECONDS AND GO DIM,
YOU MAY HAVE A PROBLEM WITH YOUR ZAGGkeys
PRO/PROplus. PLEASE CONTACT CUSTOMER
SUPPORT AT ZAGG.COM TO RESOLVE THIS PROBLEM.
TROUBLESHOOTING
FOLD
PAGE 7
PAGE 2
To Next Page
Loading...
