How to fix small leak from Zanussi ZANZDLN6531 door?
If there is a small leak from the door of your Zanussi Dishwasher, the appliance may not be levelled. Loosen or tighten the adjustable feet to correct this. Also, the door may not be centred on the tub; adjust the rear foot if applicable.
What causes whitish streaks on dishes from my Zanussi ZANZDLN6531?
Whitish streaks or bluish layers on glasses and dishes from your Zanussi Dishwasher are often due to the released quantity of rinse aid being too high. Adjust the rinse aid dosage to a lower level. Also, the quantity of detergent may be too high.
What to do if my Zanussi ZANZDLN6531 Dishwasher has stains on dishes?
If your Zanussi Dishwasher leaves stains and dry water drops on glasses and dishes, the released quantity of rinse aid may not be sufficient. Adjust the rinse aid dosage to a higher level. Also, the quality of the rinse aid could be the cause.
What to do if my Zanussi ZANZDLN6531 Dishwasher programme does not start?
If your Zanussi Dishwasher doesn't start, first ensure the appliance door is fully closed. If the delay start function is activated, either cancel it or wait for the countdown to finish. Also, the appliance may be recharging the resin inside the water softener, which takes about 5 minutes.
What to do if the anti-flood device is on and the display shows i30 on my Zanussi Dishwasher?
If the anti-flood device on your Zanussi Dishwasher is activated and the display shows i30, close the water tap. Ensure that the appliance is correctly installed and that the baskets are loaded as instructed in the user manual.
General| Type | Freestanding |
|---|---|
| Appliance placement | Freestanding |
| Number of Place Settings | 13 |
| Noise Level | 46 dB |
| Dimensions (H x W x D) | 85 x 60 x 60 cm |
| Control panel colour | Black |
| Noise emission class | C |
| Number of washing programs | 6 |
| Half Load Option | Yes |
| Programs | Eco, Glass, Intensive, Normal, Quick |
| Delay Start | Yes |
To Next Page
