Problem Possible cause Remedy
Conductance of water at installation
site differs from standard setting of
machine.
1)
Re-programme standard setting for
degree of drying (see ‘Machine set-
tings’ chapter)
1)
.
To little free space around the appli-
ance
Ensure min. 5cm free space around
the appliance
Loading door does not close.
Filter not in place
2)
. Install filter into place
2)
.
Drying cycle ends shortly after pro-
gramme starts.
Not enough washing loaded or wash-
ing loaded is too dry for selected
programme.
Select time programme or higher
drying level (e.g. EXTRA DRY instead
of CUPBOARD DRY ).
Drying cycle lasts an unusually long
time. Note: After around 5 hours the
drying cycle ends automatically.
Filter clogged. Clean filter.
Load volume too big. Reduce load volume.
Laundry insufficiently spun. Laundry must be adequately spun.
1) Only dryers with conductance programming
2) Only dryers with removable filter
Machine settings
BUZZER permanent off
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE and TEXTILE
buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off.
Technical data
height x width x depth 85 x 60 x 58 cm
drum volume 108 l
depth with the load door opened 109 cm
adjustable height 1.5 cm
the appliance weight 32 kg
maximum load volume 7 kg
voltage 230-240 V
necessary fuse 13 A
total power 2350 W
energy efficiency class C
energy consumption kWh/cycle
1)
3,9 kWh
annual energy consumption 263,1 kWh
type of use Domestic
10
www.zanussi.com
To Next Page