What to do if my Zanussi ZDF12001XA Dishwasher doesn't fill with water?
If your Zanussi Dishwasher doesn't fill with water, and the indicator flashes 1 time intermittently or continuously, ensure the water tap is fully open. Check that the water supply pressure isn't too low by contacting your local water authority. Also, inspect the water tap and the filter in the inlet hose for any clogs. Finally, make sure the inlet hose isn't kinked or bent.
What to do if my Zanussi ZDF12001XA doesn't drain the water?
If your Zanussi Dishwasher isn't draining water, and the indicator flashes 2 times intermittently or continuously, check that the sink spigot is not clogged. Also, make sure that the drain hose has no kinks or bends.
What to do if Zanussi Dishwasher programme does not start?
If the programme on your Zanussi Dishwasher doesn't start, make sure the appliance door is fully closed and press the Start button. Also, the appliance may have started the procedure to recharge the resin inside the water softener, which takes approximately 5 minutes.
What to do if the anti-flood device is on in Zanussi ZDF12001XA?
If the anti-flood device on your Zanussi Dishwasher is activated, and the indicator flashes 3 times intermittently or continuously, close the water tap and contact the Service.
General| Type | Freestanding |
|---|---|
| Number of Place Settings | 12 |
| Noise Level | 49 dB |
| Programmes | 6 |
| Size | Full-size |
| Washing performance class | A |
| Drying performance class | A |
| Delay Start | Yes |
| Half Load Option | Yes |
| Dimensions (H x W x D) | 850 x 600 x 600 mm |
| Drying System | Condenser |
To Next Page