Why is there detergent left in the Zanussi ZDF22002XA dispenser?
If you find detergent residues in the dispenser of your Zanussi Dishwasher after a cycle, it could be because: * The detergent tablet got stuck in the dispenser. * Water can't wash away the detergent because the spray arm is blocked. * Items in the baskets are preventing the dispenser lid from opening.
What to do if my Zanussi Dishwasher won't start?
If your Zanussi Dishwasher programme isn't starting, make sure the appliance door is properly closed. Press the start button. If a delay start is set, either cancel it or wait for the countdown to complete. Also, the appliance may be undergoing a procedure to recharge the resin inside the water softener, which takes about 5 minutes.
How to fix small leak from the Zanussi Dishwasher door?
If you notice a small leak from your Zanussi Dishwasher door, it could be due to the appliance not being level. Try loosening or tightening the adjustable feet to level it. Also, the door might not be centered on the tub; adjust the rear foot to correct this.
What to do if my Zanussi Dishwasher won't drain the water?
If your Zanussi Dishwasher isn't draining water, check if the sink spigot is clogged. If the end indicator flashes twice intermittently or continuously, this could be the reason. Also, make sure the drain hose isn't kinked or bent, which could obstruct water flow.
What to do if my Zanussi Dishwasher doesn't fill with water?
If your Zanussi Dishwasher isn't filling with water, check the following: * Ensure the water tap is fully open. * Verify that the water supply pressure isn't too low. Contact your local water authority for information. * Confirm the water tap isn't clogged. * Check that the filter in the inlet hose isn't clogged. * Ensure the inlet hose has no kinks or bends.
Why does the Zanussi Dishwasher program last too long?
If the program on your Zanussi Dishwasher is lasting too long, check if the delayed start option is set. If it is, cancel the delay setting or wait for the countdown to finish.
How to remove rust from cutlery in Zanussi ZDF22002XA?
If you see traces of rust on cutlery after using your Zanussi Dishwasher: * There may be too much salt in the water used for washing. * Silver and stainless steel cutlery may have been placed together. Avoid placing these items close together.
How to prevent dull tableware in Zanussi ZDF22002XA?
To prevent dull, discolored, or chipped tableware in your Zanussi Dishwasher: * Make sure that only dishwasher-safe items are washed in the appliance. * Load and unload the basket carefully. * Place delicate items in the upper basket.
What to do if anti-flood device is on in my Zanussi Dishwasher?
If the anti-flood device is activated on your Zanussi Dishwasher and the end indicator flashes three times intermittently or continuously, close the water tap and contact an Authorised Service Centre.
Why is my Zanussi ZDF22002XA Dishwasher not draining water?
If your Zanussi Dishwasher isn't draining water, check to make sure that the sink spigot is not clogged. Also, ensure that the drain hose has no kinks or bends.
General| Brand | Zanussi |
|---|---|
| Model | ZDF22002XA |
| Category | Dishwasher |
| Language | English |
To Next Page
