How to fix Zanussi ZDSN653X1 Dishwasher not filling with water (i10 or i11 error)?
If your Zanussi Dishwasher is not filling with water and the display shows i10 or i11, make sure the water tap is fully open and that the water supply pressure is adequate. Check that the water tap and the filter in the inlet hose are not clogged. Also, ensure the inlet hose isn't kinked or bent.
What to do if my Zanussi ZDSN653X1 does not drain water and shows i20?
If your Zanussi Dishwasher is not draining water and the display shows i20, check that the sink spigot and the interior filter system are not clogged. Also, make sure the drain hose isn't kinked or bent.
Why is my Zanussi Dishwasher door leaking?
If there is a small leak from the door of your Zanussi Dishwasher, the appliance may not be level. Try loosening or tightening the adjustable feet. If that doesn't work, the door may not be centered; adjust the rear foot if applicable.
Why does the Zanussi ZDSN653X1 Dishwasher programme last too long?
If the programme on your Zanussi Dishwasher is running longer than expected, check if the delayed start option is enabled. If it is, you can either cancel the delay setting or wait for the countdown to finish.
Why does my Zanussi Dishwasher trip the circuit breaker?
If your Zanussi Dishwasher trips the circuit breaker, it could be due to insufficient amperage to power all appliances simultaneously. Check the socket amperage and meter capacity, or turn off another appliance. If that's not the case, there may be an internal electrical fault, and you should contact an Authorised Service Centre.
What to do if my Zanussi Dishwasher programme does not start?
If your Zanussi Dishwasher won't start, ensure the door is fully closed. Also, check if the delay start function is activated; either cancel the setting or wait for the countdown to finish. The appliance may also be recharging the resin inside the water softener, which takes about 5 minutes.
What to do if anti-flood device is on and Zanussi ZDSN653X1 Dishwasher displays i30?
If the anti-flood device on your Zanussi Dishwasher is activated and the display shows i30, close the water tap. Ensure the appliance is correctly installed and that the baskets are loaded as instructed in the user manual.
What does i41 - i44 mean on my Zanussi ZDSN653X1?
If your Zanussi Dishwasher displays i41 - i44, indicating a malfunction of the water level detection sensor, ensure that the filters are clean. If the issue persists, try switching the appliance off and then on again.
What does error code i51 - i59 mean on Zanussi ZDSN653X1?
If your Zanussi Dishwasher displays i51 - i59 or i5A - i5F, indicating a malfunction of the wash pump or the drain pump, try switching the appliance off and then on again.
What does error code i61 or i69 mean on Zanussi ZDSN653X1?
If your Zanussi Dishwasher displays i61 or i69, indicating the water temperature is too high or there's a temperature sensor malfunction, make sure the inlet water temperature does not exceed 60°C. You can also try switching the appliance off and on again.
General| Brand | Zanussi |
|---|---|
| Model | ZDSN653X1 |
| Category | Dishwasher |
| Language | English |
To Next Page
