What causes unusual foam during washing in my Zanussi ZDSN151X1?
Unusual foam during washing in your Zanussi Dishwasher can be due to using the wrong type of detergent. Use a detergent specifically designed for dishwashers or try a detergent from a different manufacturer. Also, avoid pre-rinsing dishes under running water.
What to do if my Zanussi ZDSN151X1 Dishwasher doesn't drain the water?
If your Zanussi Dishwasher isn't draining water, check these items: * Make sure the sink spigot is not clogged. * Make sure the interior filter system is not clogged. * Ensure the drain hose has no kinks or bends.
What to do if my Zanussi ZDSN151X1 doesn't fill with water?
If your Zanussi Dishwasher isn't filling with water, make sure the water tap is fully open and that the water supply pressure isn't too low. Also, check that the water tap and the filter in the inlet hose are not clogged. Finally, ensure the inlet hose has no kinks or bends.
Why my Zanussi ZDSN151X1 is not turning on?
If you cannot activate your Zanussi Dishwasher, ensure that the mains plug is properly connected to the mains socket and that there is no damaged fuse in the fuse box.
Why are my dishes wet after Zanussi ZDSN151X1 cycle?
If the dishes are wet after a Zanussi Dishwasher cycle, activate the AirDry function for best drying results. Other potential causes include: the programme not having a drying phase or having one with a low temperature, an empty rinse aid dispenser, the quality of the rinse aid, or the quality of the multi-tablets. Consider trying a different brand of multi-tablets or activating the rinse aid dispenser and using rinse aid and multi-tablets together.
What to do if the anti-flood device is on in my Zanussi ZDSN151X1?
If the anti-flood device is activated on your Zanussi Dishwasher, close the water tap immediately. Make sure that the appliance is correctly installed and the baskets are loaded as instructed in the user manual.
What to do if my Zanussi Dishwasher has malfunction of the water level detection sensor?
If your Zanussi Dishwasher is showing a malfunction of the water level detection sensor, make sure that the filters are clean. If the issue persists, switch the appliance off and on.
Why are there residues of detergent in my Zanussi ZDSN151X1 Dishwasher dispenser?
If there are residues of detergent in the dispenser of your Zanussi Dishwasher at the end of the programme, it could be that the detergent tablet got stuck in the dispenser and was not washed away by water. Another possible cause is that water cannot wash away the detergent from the dispenser because the spray arm is blocked or clogged. Also, make sure that items in the baskets do not impede the lid of the detergent dispenser from opening.
Why are there stains on dishes from my Zanussi Dishwasher?
Stains and dry water drops on glasses and dishes from your Zanussi Dishwasher could be because the released quantity of rinse aid is not sufficient, so adjust the rinse aid dosage to a higher level. The quality of the rinse aid can also be a factor.
How to fix poor washing results with my Zanussi Dishwasher?
To improve washing results with your Zanussi Dishwasher, try using more intensive washing programmes. Also, clean the spray arm jets and the filter.
General| Type | Freestanding |
|---|---|
| Number of Place Settings | 13 |
| Energy Efficiency Class | E |
| Noise Level | 49 dB |
| Programs | 6 |
| Appliance placement | Freestanding |
| Product size | Full-size |
| Width | 60 cm |
| Delay Start | Yes |
| Half Load Option | No |
| Washing programs | Eco, Intensive, Normal |
| Height | 85 cm |
To Next Page
