How to prevent too much frost and ice in my Zanussi ZNNN18ES3?
If there is too much frost and ice in your Zanussi Freezer, make sure the door is closed correctly. Wrap the food products better. Also, check if the temperature is set correctly and set a higher temperature if the appliance is fully loaded and set to the lowest temperature.
What does it mean when the temperature setting LEDs flash on my Zanussi ZNNN18ES3?
If the temperature setting LEDs are flashing at the same time on your Zanussi Freezer, contact the nearest Authorised Service Centre. The cooling system will continue to keep food products cold, but temperature adjustment will not be possible.
What to do if the temperature in my Zanussi ZNNN18ES3 is too high or too low?
If the temperature in your Zanussi Freezer is too high or too low, the first thing to do is set the correct temperature. Also, avoid storing too many food products at the same time, and allow food products to cool to room temperature before storage. Make sure the door is closed correctly and only open the door when necessary. Check if the FastFreeze function is on.
Why does the compressor operate continually in my Zanussi ZNNN18ES3 Freezer?
If your Zanussi Freezer compressor is running constantly, it could be due to several reasons. Check if the temperature is set correctly. If you've recently added a lot of food, give it a few hours before checking the temperature again. Ensure the room temperature isn't too high, and that food items were cooled before storing them. Also, make sure the door is properly closed and that the FastFreeze function is not activated.
Why Zanussi Freezer door does not open easily?
If the door of your Zanussi Freezer doesn't open easily, it's likely because you tried to reopen it immediately after closing it. Wait a few seconds between closing and reopening the door.
What to do if the temperature cannot be set on my Zanussi Freezer?
If you cannot set the temperature on your Zanussi Freezer, switch off the FastFreeze function manually, or wait until the function deactivates automatically to set the temperature.
How to fix a Zanussi ZNNN18ES3 Freezer that does not operate?
If your Zanussi Freezer isn't operating, first ensure that it is switched on. Then, check that the mains plug is correctly connected to the mains socket. Finally, verify that there is voltage in the mains socket by connecting another electrical appliance or contacting a qualified electrician.
General| Type | Upright Freezer |
|---|---|
| Colour | White |
| Frost Free | Yes |
| Freezing capacity | 4.5 kg/24h |
| Depth | 650 mm |
| Control Type | Mechanical |
| Defrosting | Automatic |
| Number of Shelves | 4 |
| Defrost System | Automatic |
| Climate class | SN, N, ST, T |
| Width | 60 cm |
| Net capacity | 182 liters |
| Height | 1850 mm |
To Next Page
