How to turn off DEMO mode on Zanussi Freezer?
If you see DEMO on the display of your Zanussi Freezer, it means the appliance is in demonstration mode. To exit this mode, keep the OK key pressed for about 10 seconds. You should hear a long sound, and the display will turn off briefly.
Why is there too much frost and ice in my Zanussi ZUNN18FS1 Freezer?
If there is too much frost and ice in your Zanussi Freezer, make sure that food products are properly wrapped. Also, consider adjusting the temperature to a higher setting if it's set too low or if the appliance is fully loaded.
Why is water flowing on the floor from my Zanussi ZUNN18FS1?
If water flows on the floor from your Zanussi Freezer, it's likely that the melting water outlet isn't correctly connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray.
What to do if my Zanussi ZUNN18FS1 does not operate?
If your Zanussi Freezer isn't working, first, ensure that the appliance is switched on. Then, check if the mains plug is correctly connected to the mains socket. If the issue persists, test the mains socket with another electrical appliance to confirm it's working. If there's still no voltage, contact a qualified electrician.
Why does the compressor in my Zanussi ZUNN18FS1 Freezer operate continually?
If your Zanussi Freezer's compressor runs continually, the temperature may be set incorrectly. Also, putting many food products in at the same time, high room temperature, food products placed in the appliance that were too warm, the door not closed correctly, or the FastFreeze function being switched on could be the cause. Wait a few hours and then check the temperature again. Allow food products to cool to room temperature before storing.
What to do if the temperature in my Zanussi ZUNN18FS1 Freezer is too low or too high?
If the temperature in your Zanussi Freezer is too low or too high, try setting a higher or lower temperature. Ensure food products are cooled to room temperature before storing and avoid storing too many items at once. Also, reduce how often you open the door.
Why doesn't the door of my Zanussi ZUNN18FS1 open easily?
If your Zanussi Freezer door doesn't open easily, it might be because you're trying to reopen it immediately after closing it. Wait a few seconds before trying to reopen the door.
Why temperature cannot be set on my Zanussi Freezer?
If you cannot set the temperature on your Zanussi Freezer, the "FastFreeze function" might be switched on. Turn off the "FastFreeze function" manually or wait for it to deactivate automatically to adjust the temperature.
What does it mean if A or or symbol is shown instead of numbers on the temperature display of my Zanussi Freezer?
If you see an 'A' or 'or' symbol instead of numbers on the temperature display of your Zanussi Freezer, it indicates a temperature sensor problem. Contact the nearest Authorized Service Centre.
General| Type | Upright freezer |
|---|---|
| Energy Efficiency Class | F |
| Number of Freezer Drawers | 4 |
| Fast Freeze Function | Yes |
| Category | Freezer |
| Built-in | No |
| Freezing capacity | 4.5 kg/24h |
| Climate class | SN-T |
| Colour | White |
| Defrost System | Manual |
| Reversible Door | Yes |
| Net Freezer Capacity | 168 liters |
| Energy consumption annual | 188 kWh |
| Freezer Net capacity | 168 liters |
| Annual Energy Consumption | 188 kWh |
| Total Capacity | 168 liters |
To Next Page
