zapco DC-352 - Page 29

SPECIFICATIONS
The above specifications shall be modified by manufacturer for improvement without prior notice.
Rated power output
-RMS power, 4 ohms mono -------
-RMS power, 2 ohms momo -------
Signal to Noise Ratio ------------------
Frequency Response ------------------
THD@RMS Watts ----------------------
Slew rate ------------------------------
Damping factor -----------------------
Fuse Rating ---------------------------
Input Sensitivity ----------------------
Dimensions (mm) ---------------------
350W x 1CH
500W x 1CH
>85dB
20Hz ~ 20KHz (+/-0.5dB)
0.013%
>25 V/µS
>600@4
20A x 3
500mV~10V (+/- 5%)
340(L) x 55(H) x 180(W)
DC-501 DC-1101
800W x 1CH
1200W x 1CH
>95dB
20Hz ~ 20KHz (+/-0.5dB)
0.03%
>40 V/µS
>800@4
40A x 3
500mV~10V (+/- 5%)
600(L) x 55(H) x 180(W)
Rated power output
-RMS power, 4 ohms stereo ---------------------------------------
-RMS power, 2 ohms stereo ---------------------------------------
Signal to Noise Ratio --------------------------------------------------
Frequency Response --------------------------------------------------
THD@RMS Watts ------------------------------------------------------
Channel Separation ---------------------------------------------------
Slew rate ---------------------------------------------------------------
Damping factor --------------------------------------------------------
Fuse Rating ------------------------------------------------------------
Input Sensitivity -------------------------------------------------------
Dimensions (mm) -----------------------------------------------------
DC-656
50W x 4CH + 100W x 2
90W x 4CH + 180W x 2
>95dB
20Hz ~ 20KHz (+/-0.5dB)
0.02%
>23 V/µS
60dB
>160@4
40A x 3
500mV~10V (+/- 5%)
600(L) x 55(H) x 180(W)
-29-