Need help?Do you have a question about the zapco STUDIO 50 and is the answer not in the manual?
Provides essential guidelines for mounting the amplifier, stressing ventilation, heat avoidance, and vibration isolation.
General| Output Power | 25 watts/ch @ 4Ω, 20Hz-20kHz 50 watts/ch @ 2Ω, 20Hz-20kHz |
|---|---|
| Power Requirements | 15 Amperes max. @ 2 ohms |
| Fuse Rating | Internal, 20 Amperes |
| Idle Current | .72 Amperes |
| T.H.D. + Noise | <.04%, 20Hz-20kHz @ 25 watts/ch, 4Ω <.05%, 20Hz-20kHz @ 50 watts/ch, 2Ω |
| S/N Ratio | >100dB |
| Dynamic Headroom | 1.5dB @ 2 ohm load |
| Separation | >65dB |
| Damping Factor | >100 @ 4 ohms |
| Input Type | Fully isolated RCA |
| Input Sensitivity | 230mV - 2.3 Volts, variable |
| Maximum Input Level | 2.3 Volts R.M.S. |
| Input Impedance | 47K ohms |
| Minimum Load | 2 ohms stereo - 4 ohms mono |
Weight and Dimensions| Dimensions | 8.5”L x 5-7/8”W x 2-1/4”H |
|---|
To Next Page