Need help?Do you have a question about the zapco STUDIO 100 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| RMS Power at 4 Ohms | 50W x 2 |
| RMS Power at 2 Ohms | 75W x 2 |
| Bridged RMS Power at 4 Ohms | 150W x 1 |
| THD at Rated Power | < 0.05% |
| Signal to Noise Ratio | >95 dB |
| Damping Factor | >200 |
| Frequency Response | 10Hz - 30kHz |
| Crossover Frequency | 50Hz - 5kHz |
| Crossover Slope | 12dB/octave |
| Crossover | High-pass/Low-pass |
An introduction to the Zapco Studio 100 stereo power amplifier.
Highlights of the amplifier's symmetrical circuitry, feedback, and connectors.
Instructions for unpacking and guidelines for mounting the Studio 100 amplifier.
Guide to correctly connecting the power supply for the Studio 100 amplifier.
Instructions for connecting audio inputs and speakers to the Studio 100.
Safety precautions for wiring, operation, and hearing protection for the amplifier.
Detailed performance parameters, impedance, and power requirements for the Studio 100.
Contact information for support, troubleshooting, and product return procedures.
A graph illustrating the Studio 100's power output capabilities versus distortion levels.
Information about the design and manufacturing process of the Studio 100 in the USA.
To Next Page
