Page 45
After changing a parameter, press ENTER to confirm data when requested by the mes-
sage on the console. Parameters modified and optimized on one unit can be stored by the
console (SAVE) and then released (RESTORE) on another chopper, thus allowing fast and
standardized settings (see console manual for details).
Flow Chart showing how to make Program changes using Digital Console fitted with
Eprom CK ULTRA.
1) Opening Zapi Display.
2) Press ENTER to go into the General
Menu.
3) The Display will show :
4) Press ENTER to go into the
Parameter Change facility.
5) The Display will show the first
parameter.
6) Press either ROLL UP and ROLL DOWN
to display the next parameter.
7) The names of the Parameters appear
on the Display.
8) When the desired Parameter appears, the
Display will show a Level Number that will
be between 0 and 9. Press either PARAM
(Top Right) or SET (Bottom Right)buttons
to change the Level value.
9) The Display will show the New Level.
10) When you are satisfied with the results of
the changes you have made, Press OUT.
11) The Display asks “ ARE YOU SURE"?
12) Press ENTER to accept the changes, or
press OUT if you do not wish to accept the
changes and wish to make further
modifications to the parameters.
13) The Display will show :
To Next Page
Loading...
Need help?
General
