To Next PageTo Next PageWhat to do if I get an ANALOG INPUT error (MDI/LED code = 96) on my Zapi ACE0 2mC Inverter?
This alarm for Zapi Inverter shows that the A/D conversion of the analog inputs returns frozen values on all converted signals for more than 400 ms. This indicates a failure in the A/D converter or a problem in the code flow that skips refreshing the analog signal conversion. If the problem remains, replace the logic board.
Why does my Zapi Inverter display 'ACQUIRING A.S. (MDI/LED code = 2)'?
The ACQUIRING A.S. (MDI/LED code = 2) alarm for Zapi Inverter means the controller is acquiring data from the absolute feedback sensor. The alarm will end when the acquisition is complete.
Key technical parameters including motor types, operating frequency, and environmental ratings.
Table detailing current specifications for different models and voltage configurations.
Step-by-step guidance for physically installing the controller on a vehicle.
Details the controller's built-in protection mechanisms and safety compliance standards.
Essential pre-power checks to ensure correct installation, wiring, and safety.
Detailed explanations of parameter groups like PARAMETER CHANGE, SET OPTIONS, and ADJUSTMENTS.
Explains how to use the TESTER function for real-time monitoring and diagnostics of controller status.
Describes the logbook for alarms, their codes, and how to interpret them.
Lists and describes specific alarms originating from the master microcontroller and their troubleshooting.
Lists and describes specific alarms originating from the supervisor microcontroller and their troubleshooting.
General
