4
English
Important information
Before using or maintaining this product, it is important to read the following safety instructions. Failure to
follow and apply all the instructions and procedures covered in this quick guide will invalidate the guarantee
and cause Zaptec Charger AS and direct partners towaive all liability and claims for compensation.
WARNING!
! Read through the instructions carefully and
familiarise yourself with the equipment before
you start using it.
! This equipment must only be installed, repaired,
and maintained by qualified personnel. Repairs
must be carried out by Zaptec or a pre-approved
workshop.
! All applicable local, regional, and national laws
and regulations must be followed when installing,
repairing, and maintaining the product.
! Do not install or use a product which is damaged
in any way.
! Only use approved cabling for the installation.
! Do not insert foreign objects into the Type 2
socket.
! Do not use high-pressure washers to clean the
charging station. Follow the instructions in the
chapter Storage and Maintenance.
! Avoid installing the charging station where it can
be exposed to extreme temperatures, such as in
direct sunlight.
! Adapters are permissible. A conversion adapter
from the charging station outlet must only be
used if specified and approved by the vehicle
manufacturer or Zaptec.
! Extension cables are not permitted.
Status light
Type 2 socket and cover
Charge card authentication (RFID)
Display
Get to know Zaptec Go 2
Your charging station is guaranteed by Zaptec Charger AS, Vassbotnen 1, 4313 Sandnes, Norway to be free
from defects in materials and workmanship for a period of five (5) years from the date of its original purchase.
Read the full details at zaptec.com/guarantee or contact Zaptec support to request a copy. Your statutory
rights are not affected.
To Next Page
Loading...
