Zebra 105 SL - Printing Specifications

94 Zebra 105SL User’s Guide
3ULQWLQJ6SHFLILFDWLRQV
* Media registration and minimum label length are affected by media type and width, ribbon type, and print
speed. Performance improves as these factors are optimized. Zebra recommends always qualifying any
application with thorough testing.
5LEERQ6SHFLILFDWLRQV
Printing Specifications 105SL
Re so l ut ion 20 3 do t s /i nc h ( 8 d o t s /m m) /
300 dots/inch (12 dots/mm)
D o t s i ze ( w i d t h x l e n g t h ) 0 . 0 0 4 9 " x 0 . 0 0 4 9 " ( 0 . 1 2 5 m m x 0 . 1 2 5 mm ) /
0.0033" x 0.0039" (0.084 mm x 0.10 mm)
First dot location measured from inside media edge 0.10" ± 0.035" (2.5 mm ± 0.89 mm)
Maximum print width 4.1" (104 mm)
Print Length
(maximum)
Continuous printing
203 dpi 90" (2286 mm)
300 dpi 41" (1041 mm)
Media registration toleration*
(non-continuous media)
Vertical = ≤ ±0.050" (1.3 mm)
Horizontal = ≤ ±0.050" (1.3 mm)
Programmable print speeds
203 dpi 2.4" (61 mm) t hro ugh 8.0" (203 mm)
per second in 1" increments
300 dpi 2.4" (61 mm) t hro ugh 8.0" (203 mm)
per second in 1" increments
Bar code modulus
(“X”) dimension
Ladder (rotated)
orientation
203 dpi 4.9 mil to 49 mil
300 dpi 3.9 mil to 39 mil
Picket fence (non-
rotated) orientation
203 dpi 4.9 mil to 49 mil
300 dpi 3.3 mil to 33 mil
Thin film printhead with Element Energy Equalizer (E3)
®
Yes
Ribbon Specifications 105SL
Ribbon must be wound with the coated side out.
Ribbon width (Zebra recommends using ribbon at least as
wide as the media to protect the printhead from wear.)
Minimum 0.79" (20 mm)
Maximum 4.1" (104 mm)
Standard lengths
2:1 media to ribbon roll ratio 984 ft. (300 m)
3:1 media to ribbon roll ratio 1476 ft. (450 m)
Ribbon core inside diameter 1.0" (25.4 mm)
Maximum ribbon roll outside diameter 3.2" (81.3 mm)