Zebra 105 SL - Page 24

16 Zebra 105SL User’s Guide
&RQILJXULQJWKH6RIWZDUHRU3ULQWHU'ULYHU
Many printer settings may also be controlled by your printer’s driver or
label preparation software. Please refer to the driver or software
documentation for more information.
Press Display
Shows
Action/Explanation
— PRINTER READY Normal printer operation.
DARKNESS Press the (+) or (–) keys to increase or decrease the print
darkness setting. (You may need to change this setting when
you print your label.)
PRINT MODE Press the (+) or (–) keys to select tear-off, peel-off, cutter, or
rewind mode.
MEDIA TYPE Press the (+) or (–) keys to select continuous or non-continuous
media type. (If you choose continuous media, you must also
include a label length instruction in your label format.)
SENSOR TYPE Press the (+) or (–) keys to select transmissive or black mark
sensing mode. Unless your media has black marks on the
back, leave your printer at the default setting (web).
PRINT METHOD Press the (+) or (–) keys to select thermal transfer (if you are
using ribbon) or direct thermal (no ribbon).
MAXIMUM
LENGTH
Press the (+) or (–) keys to set the value that is closest to, but
not less than, the length of the label you are using.
SAVE SETTINGS Press the (+) or (–) keys to select:
PERMANENT — saves changes when the power is turned off.
Press NEXT/SAVE to accept the selection.
— PRINTER READY You have exited the configuration mode and are ready to
calibrate the printer.