Zebra 105 SL - Page 27

Zebra 105SL User’s Guide 19
3ULQWLQJD7HVW/DEHO
To print a test label:
1. Turn off the printer.
2. Press and hold the CANCEL key
while turning on the printer.
A configuration label prints showing
the printer’s currently stored
parameters (similar to the one shown
in Figure 11).
If you encounter any problems while
you are configuring or calibrating the
printer or printing a test label, refer to
“Troubleshooting” beginning on
page 79. Otherwise, refer to
“Establishing Communication”
beginning on page 21 to set up the
communication parameters.
Figure 11