Zebra 105 SL - Page 50

42 Zebra 105SL User’s Guide
5LEERQ5HPRYDO
Refer to Figure 25.
1. If the ribbon is not exhausted, cut or break it as close to the ribbon
take-up spindle as possible.
2. Push the hook either forward or backward with your thumb until it
slips out of the groove (1). Slide the hook to the side (2), then rotate it
back and forth several times to loosen it (3).
3. Remove the loosened hook from the spindle (4).
4. Lightly tap the top of the used ribbon to loosen it; grasp the used
ribbon and remove it from the ribbon take-up spindle.
5. Remove the core from the ribbon supply spindle.
6. Follow the ribbon loading procedure on page 40 to load the new
ribbon.
Figure 25