50 Zebra 105SL User’s Guide
Press Display Shows Action/Explanation
INITIALIZE CARD
Initialize Memory Card
CAUTION: Perform this operation only when it is necessary to
erase all previously stored information from the optional memory
card (for printers with a PCMCIA slot). Press the NEXT/SAVE key
to bypass this function.
1. Press the (+) key to select “YES.”
If your printer is set to require a password, you are
prompted to enter the password. Enter the password and
then press the NEXT/SAVE key.
2. The display asks “INITIALIZE CARD?”. Press the (+) key to
select “YES.”
3. The front panel LCD asks “ARE YOU SURE?”.
4. Press the (+) key “YES” to begin initialization.
or
Press the (–) key “NO” to cancel the request and return to the
“INITIALIZE CARD” prompt.
5. Press the SETUP/EXIT key followed by the NEXT/SAVE key.
If initialization is still in process, the front panel display
flashes back and forth between the two phrases
“CHECKING B: MEMORY” and “PRINTER IDLE.”
When initialization is complete, the printer
automatically exits the configuration mode and the
front panel displays “PRINTER READY.”
NOTE: Depending on the amount of memory in the memory
card, initialization may take up to five minutes to
complete.
To Next Page
Loading...