Zebra 105SL User’s Guide 57
Selecting Prefix and Delimiter Characters
Prefix and delimiter characters are 2-digit hex values used within the ZPL/ZPL II formats sent to the printer.
The printer uses the last prefix and delimiter characters sent to it, whether from a ZPL II instruction or from
the front panel.
NOTE: DO NOT use the same hex value for the control, format, and delimiter character. The
printer needs to see different characters to function properly.
Press Display Shows Action/Explanation
CONTROL PREFIX
Control Prefix Character: Press the (–) key to move to the
next digit position, press the (+) key to increase the value of the
digit.
Default: 7E (tilde — displayed as a black square)
Range: 00-FF
The printer looks for this 2-digit hex character to indicate the
start of a ZPL/ZPL II control instruction.
FORMAT PREFIX
Format Prefix Character: Press the (–) key to move to the
next digit position, press the (+) key to increase the value of the
digit.
Default: 5E (caret)
Range: 00 - FF
The printer looks for this 2-digit hex character to indicate the
start of a ZPL/ZPL II format instruction.
DELIMITER CHAR
Delimiter Character: Press the (–) key to move to the next
digit position, press the (+) key to increase the value of the
digit.
Default: 2C (comma)
Range: 00 - FF
The delimiter character is a 2-digit hex value used as a
parameter place marker in ZPL/ZPL II format instructions.
Refer to the ZPL II Programming Guide Volume I for more
information.
To Next Page
Loading...