32056L Rev. 2 12/4/01 105SL Maintenance Manual Page 4-1
PREVENTIVE AND CORRECTIVE MAINTENANCE SECTION 4
6(&7,21
35(9(17,9($1'&255(&7,9(0$,17(1$1&(
6$)(7<,1)250$7,21
(48,30(176$)(7<7,36
After reviewing each procedure, place a check in the box.
The AC power plug and IEC 320 connectors on all Zebra Printers must bear the
certification mark of at least one of the international safety organizations listed
below.
Unless indicated otherwise, turn the power OFF before performing any
maintenance procedures to the printer. Disconnect the AC power cord from the
power source.
Zebra printers comply with international regulations governing radiated emissions
when using fully shielded data cables. Data cables must be fully shielded and fitted
with metal or metalized connector shells. Required shielded data cables and
connectors prevent radiation and reception of electrical noise. Use of unshielded
data cables may increase radiated emissions above the regulated limits.
Permanent damage to the Flash Memory will result if you power up the printer with
Flash Memory chips installed in the wrong direction.
To Next Page
Loading...
