Zebra Z4Mplus Maintenance Manual

13358L Rev. 1 11/17/03 Z4Mplus and Z6Mplus Maintenance Manual xiii
List of Figures
List of Figures
Section 1 System Description
Figure 1-1. Default Fonts Examples .................................................................................................. 5
Figure 1-2. Interface Connections Z4Mplus and Z6Mplus ...................................................................9
Figure 1-3. RS-232 Connections ..................................................................................................... 11
Figure 1-4. DTE to DTE Interconnection .......................................................................................... 11
Figure 1-5. RS-232 Cable Connections ...........................................................................................12
Figure 1-6. DB-9 to DB-25 Connections ..........................................................................................13
Figure 1-7. RS-422/RS-485 Interconnecting Cable ......................................................................... 14
Figure 1-8. RS-232 Signaling ........................................................................................................... 15
Figure 1-9. RS-422/RS-485 Signaling ............................................................................................. 16
Section 2 Operations Overview
Figure 2-1. Location of Control Panel Keys .....................................................................................20
Figure 2-2. Ribbon Loading ............................................................................................................. 23
Figure 2-3. Media Loading Tear-Off Mode ....................................................................................... 24
Figure 2-4. Media Loading Cutter Mode ..........................................................................................25
Figure 2-5. Media Loading Peel ....................................................................................................... 27
Figure 2-6. Locate Slot ..................................................................................................................... 28
Figure 2-7. Media Loading Peel with Liner Take-up ........................................................................ 29
Figure 2-8. Remove Liner ................................................................................................................ 29
Figure 2-9. Peel Rewind (Peel-Off Mode) ........................................................................................31
Figure 2-10. Peel Rewind (Rewind Mode) ....................................................................................... 33
Figure 2-11. Peel Rewind Media Adjustment ................................................................................... 34
Figure 2-12. Media Loading Fanfold ................................................................................................ 36
Figure 2-13. Adjusting the Optional Transmissive Sensor ............................................................... 38
Figure 2-14. Cancel Key Self Test Label (Configuration Label) ....................................................... 41
Figure 2-15. PAUSE Key Self Test Label ........................................................................................ 42
Figure 2-16. Feed Key Self Test Label ............................................................................................ 43
Figure 2-17. Pause and Cancel Key Self Test Label ....................................................................... 44
Figure 2-18. Communications Diagnostics Self Test ....................................................................... 45

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing