Zebra Z4Mplus Maintenance Manual

viii Z4Mplus and Z6Mplus Maintenance Manual 13358L Rev. 1 11/17/03
Table of Contents
Replace Power Supply Board .............................................................................................. 89
Remove the Power Supply Board .................................................................................. 89
Install the Power Supply Board ...................................................................................... 93
Replace Drive Belt ............................................................................................................... 98
Remove Drive Belt ......................................................................................................... 98
Install Drive Belt ........................................................................................................... 100
Replace Front Panel .......................................................................................................... 101
Remove Front Panel .................................................................................................... 101
Install Front Panel ........................................................................................................ 103
Replace the Dancer Assembly ........................................................................................... 105
Remove the Dancer Assembly ..................................................................................... 105
Install Dancer Assembly ............................................................................................... 107
Replace Ribbon/Head Open Sensor .................................................................................. 108
Remove Ribbon /Head Open Sensor Assembly .......................................................... 108
Install Ribbon/Head Open Sensor Assembly ............................................................... 111
Replace Transmissive Sensor ........................................................................................... 113
Remove Transmissive Sensor ..................................................................................... 113
Install Transmissive Sensor ......................................................................................... 116
Replace Reflective Media Sensor ...................................................................................... 117
Remove Reflective Media Sensor Assembly ............................................................... 117
Install the Reflective Media Sensor Assembly ............................................................. 120
Replace Ribbon Take-Up Assembly .................................................................................. 122
Remove Ribbon Take-Up Assembly ............................................................................ 122
Install Ribbon Take-Up Assembly ................................................................................ 124
Replace Ribbon Supply Assembly ..................................................................................... 125
Remove Ribbon Supply Assembly ............................................................................... 125
Install Ribbon Supply Assembly ................................................................................... 128
Replace Media Hanger ...................................................................................................... 131
Remove Media Hanger ................................................................................................ 131
Install Media Hanger .................................................................................................... 131

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing