30
Setup
Attaching Power
1/13/2016 ZD420 User’s Guide 212485-001 Rev. A
Attaching Power
1. Plug the power supply into the printer’s DC power receptacle.
2. Insert the AC power cord into the power supply.
3. Plug the other end of the AC power cord into an appropriate AC electrical outlet. Note that AC
outlet end of the power cord’s plug type can vary by region.
4. The active power light will turn on green if power is on at the AC outlet.
Important • Set up your printer so that you can handle the power cord easily if needed. To
make certain the printer cannot carry electrical current, you must separate the power cord
from the power supply receptacle or AC electrical outlet.
Caution • Never operate the printer and power supply in an area where they can get wet.
Serious personal injury could result!
Note • Ensure the appropriate power cord with a three (3) prong plug and an
IEC 60320-C13 connector are used at all times. These power cords must bear the
relevant certification mark of the country in which the product is being used.
To Next Page
Loading...
