Zebra ZQ320 - Printer LED Behavior; Normal Boot-up LED Behavior; Sleep Mode LED Behavior; Shutdown LED Behavior

P1096702-001 • ZQ320 Repair Procedures • 2-33 •
Repair Kit P1093300-008
Installation Instructions
This kit includes the parts necessary to install 802.11AC Radio PCBA. Read these
instructions thoroughly before attempting to install this kit.
Tools Required
• T5 TORX Driver (0.75 +/- 0.3 in. lb.)
Removing the 802.11AC Radio PCBA
1. Locate the Radio PCBA on the Top
PCBA. Use a T5 TORX driver to
remove the two screws securing the
PCBA to the Top board.
2. Lift the Radio board off the Top
board.
3. Disconnect the antenna cable from
the Radio board.