P1096702-001 • ZQ320 Repair Procedures • 2-34 •
Installing the 802.11AC Radio PCBA
1. Connect the Radio PCBA to the
corresponding connector (circled) on
the Top Board. Use a T5 driver (0.75
+/- 0.3 in. lb.) on the two (2) screws
that secure it to the Top Board.
2. Snap the antenna cable onto the
Radio Board (where shown).
3. Make sure that the ferrite bead on
the antenna cable assembly is seated
next to the side wall of the Lower
Housing (as shown).
To Next Page
Loading...