P1096702-001 • ZQ320 Repair Procedures • 2-36 •
Installing the Media Cover (without
Black Bar Sensor)
1. Insert the Torsion Spring into the
mounting holes located on the Lower
Housing.
2. Align the hinges of the Media Cover
Assembly with the hinges of the Lower
Housing. Make sure that the Torsion
Spring is located on the inside of the
Media Cover Assembly.
2. Slide the hinge pin through the
hinges and through the Torsion Spring.
The hinge pin should be centered with
the ends ush with the outside hinge
on either side.
To Next Page
Loading...