Zebra ZQ320 - Printer Setup Utilities; Zebra Setup Utilities (Windows); Zebra Printer Setup Utility (Android)

P1096702-001 • ZQ320 Repair Procedures • 2-43 •
Removing the Rubber Door
1. Remove the Top Cover as described
on page 2-15.
2. Locate the nub of the rubber door on
the right inside wall (inset) of the lower
housing. Take the rubber door and
slide it to the side and out of the lower
housing.
Installing the Rubber Door
1. Insert the nub on the underside of the
rubber door through the opening of
the lower housing and slide it into the
slot in the opening.
2. Ensure that the rubber door is seated
securely in the lower housing.
3. Install the Top Cover on the printer.
Slot