Zebra ZQ320 - Black Bar Label Media Design; Using Pre-Printed Receipt Media; Black Mark Dimensions for Receipts

25
ZQ300 Series User Guide
Note • Black bars are located on the back of the media and are
only shown in the above view for illustration purposes.
Black Mark Dimensions (Receipt Media)
The reective media black marks (or black bar/marks) should
extend past the centerline of the roll on the front side of the pa-
per.
• Minimum mark width: 0.59 in. (15 mm) perpendicular to the
edge of the media, and centered within the width of the
roll.
• Mark length: 0.19 - 0.24 in. (4.8 - 6.0 mm) parallel to the
edge of the media.
Safe Printing Zone
1.59 mm1.59 mm
1.25 mm
1.25 mm
“H”
Max Label Height = “H” = 2.5 mm
CPCL Label
Height
Media Feed Direction
Safe Printing Zone
Black Bar
Black Bar
Figure 14 • Black Bar Label Media
Using Pre-Printed Receipt Media
ZQ300 Series printers support alignment of pre-printed re-
ceipts by using the out of paper sensor located near the
printhead.