19
ZQ500 Series User Guide
Battery packs which are only partially discharged will take less
time to reach their charged state. Batteries which have reached
80% of their charge capacity may be used, however, it is rec-
ommended that you allow the batteries to reach a full charge to
maintain maximum battery life.
The UCLI72-4 Quad Charger has a safety feature which stops charging a
battery after six hours regardless of its charge state. If not fully charged,
it might be indicative of a battery that needs to be replaced.
Use care when installing the UCLI72-4 Quad Charger so that you do not
block the ventilating slots on the top and bottom covers. Ensure that the
charger is plugged into a power source which will not accidently be
turned off if you will be charging batteries overnight.
AC Power Adapter (included in kit p/n P1031365-024 for all
ZQ510 Printers)
Figure 4: Charging the Battery Pack with the AC Power Adapter)
ZQ510 AC
Adapter
DC Input
AC Power Cord
(varies with
geographic
location)
To Next Page
Loading...