20
ZQ500 Series User Guide
Vehicle Cradle (P1063406-029)
The ZQ500 Series Vehicle Cradle provides a means to mount a
ZQ510 and ZQ520 printer in a vehicle while at the same time pro-
viding charging power to the battery. The Vehicle Cradle features
USB connectivity to allow the user to connect a laptop or tablet
to the cradle.
Battery Eliminator (P1063406-032)/Battery Eliminator Vehicle
Cradle (P1063406-028)
The ZQ500 Series Battery Eliminator allows a vehicle based
mobile printer user to operate the printer without the use of a
battery. The Battery Elimnator Vehicle Cradle enables the user
to mount a ZQ500 Series printer in a vehicle without the use of a
battery.
4-Bay Power Station (P1063406-027)
The ZQ500 4-Bay Power Station allows a total of four (4) ZQ510
or ZQ520 printers to be docked and charged. The Power Station
provides battery charging power while still maintaining all of the
printer’s functionality.
Note • For detailed information on accessories, refer to the ZQ500VC
User Guide (P1071204-001), the ZQ500 4-Bay Power Station User Guide
(P1071266-001), the Battery Eliminator User Guide (P1071365-001), and
the Battery Eliminator Cradle User Guide (P1073631-001).
• Open the protective cover on the ZQ510 printer to expose
the DC input charger jack.
• Connect the appropriate AC power cord for your location to
the adapter and then plug the power cord into an AC recep-
tacle.
• Plug the barrel plug from the P1029871 AC adapter into the
charger jack on the printer.
• The printer will power up and begin charging. The printer
can be left on or turned off at this point. Charging will contin-
ue in either state.
Note • Batteries are shipped in sleep mode to preserve their maximum
capacity while in storage prior to initial use. Plug the battery into the
Smart Charger 2 or Quad Charger (see Pg. 17) to wake it up before using
for the first time.
While it’s possible to charge the battery when using the printer, charge
times will increase under this condition.
To Next Page
Loading...